A complete FM Radio Broadcast station capable of operating
within or beyond existing commercial power networks. It's 13.8/28
Volt DC power requirement permits battery operation from solar or
other charging sources to reach that last mile that is so
important in educational broadcasting.
Click on Picture to display larger view
Back to Top
Back to Top
- 88-108 MHz in 200 KHz steps. Frequency is easily adjusted with internal
DIP switches. These units also feature phase locked loop circuitry ensuring
high frequency stability from -25 degrees Celsius through +45 degrees
Celsius. Frequency deviation is +/- 75 KHz; distortion >0.2%;
RF Impedance 50 Ohms. Reflected power indicator and deactivation circuits ensure no burnout
of the unit.
- Six Channel Audio Mixer
- This compact mixer features a microphone input
sensitivity of 1 mV; Line output sensitivity of 100 mV. The
output level at 1 KOhm load = 1mV. The input overload on
the microphone is >250 mV. The line input is > 6
Volts. Distortion is < 0.5%. The signal to noise ratio
is > 55 dB. Frequency response is 20-20000 Hz +- 2 dB.
The power requirement for operation of the mixer are a
minimum of 9 V DC and a maximum of 13.5 V DC.
- Compact Disc/MP3 Players
- The basic unit includes two MP3/CD compact
disc players that have a signal/noise ratio of 80 dB; WRMS<0.25%. The sampling frequency is 44.1 KHz . These
units feature a Digital/Audio 1 bit converter as well as
a semi-conductor laser pickup light source. The pickup
wave length is 790 nm. The laser output of the units is
0.5 mW continuous.
- Audio Cassette Recorders/Players
- The SBS-1 includes two dual track monaural track system
recorders. Tape speed is 4.75 cm/s. It features AC Bias
recording system. Frequency response from 125
Hz-6.3 kHz is + or - 6dB. The signal to noise ratio is -40 dB; WRMS<0.35%. They are full play and record capable as
well as having pause and cue.
A tape counter permits easy location of
- The unit contains a dynamic/unidirectional microphone
with an impedance of 500 Ohms. The sensitivity of the
unit at 1 KHz is -77dB(0dB=1V/microbar). The frequency
response is 100 Hz to 10 KHz. It uses an XLR connector
and has a flexible neck for adjustment.
Back to Top
WANTOK Products and
Page Created by RC ROBBINS. firstname.lastname@example.org
Copyright © 1999 [COLINCO INC]. All rights reserved.
Information in this document is subject to change without notice.
Other products and companies referred to herein are trademarks or
registered trademarks of their respective companies or mark
Send mail to Webmaster with
questions or comments about this web site.
December 11, 2007